Digital Positioner System 20-85

Digital positioner for our models from
20NM to 85NM. Instrumentation signal 4-20mA,
0-20mA, 0-10V or 1-10V. This positioner is suitable for S, B and H models.

Digital Positioner System 140-300

Digital positioner for our models from
140NM and 300NM. Instrumentation signal
4-20mA, 0-20mA, 0-10V or 1-10V. This positioner
It is suitable for S, B and H models.

The BSR security system It is an automation that, incorporated into the J4C actuators, allows,
in the event of a power outage, place the valve in the predetermined preferred position NC or NA. Inside the actuator is located the BSR circuit card plus the block
battery that is in continuous charge, which allows the actuator to be activated, if necessary,
when the unit detects a power failure. It must be borne in mind that it is not about
a single effect actuator, but in the event that the valve is in a non-preferred position,
the BSR system, through the batteries, will activate the valve until it is placed in the predetermined position
as preferred, acting as a single acting actuator.

Interface System

Through the cable of the INTERFACE KIT we establish
communication with the actuator. we read parameters
and we change the configuration of the actuator.

We have incorporated the BLUETOOTH communication system, to be able to communicate with our actuators from any IOS or ANDROID device.
This system appears as a factory option in our catalog.
From our mobile or tablet we can order the actuator to open/close or stop at a point,
We can also find out about its current status, read parameters, find out about errors or incidents, etc. Communication with our devices remains protected with a password.
Via BLUETOOTH we detect up to a maximum of 50 actuators at a maximum distance of 20 m.

MODBUS sectorization

Plug and play
· You can manually act on the equipment
· Visible from the control panel, tablet, mobile, PC, inside and outside the plant
· Fast and flexible, we can start with 3 actuators and expand up to 32
· Range up to 1,200m
· You can power the equipment locally and communicate with a data cable
· You can name equipment, make a synoptic of the plant, send alarm emails

WIRELESS sectorization

Plug and play, just power the equipment
· You can manually act on the equipment
· Visible from the control panel, tablet, mobile, PC, inside and outside the plant
· Fast and flexible, we can start with 3 actuators and expand up to 32
· From 50m to 1,600m without repeaters
The teams are transmitters and receivers at the same time, creating a communication mesh,
that allows you to avoid obstacles such as walls or interference